1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

New Profile Posts

  1. Jenifer Luebke
  2. Shan Guto
  3. rcom zopr
  4. paulsyo logan
  5. OutsourcedGuru
    OutsourcedGuru mark tomlinson
    Regarding your post in bed-heater-installing-ssr-pid-control-instructions, "I would expect a MOSFET... to work at least as good as an SSR.", just throwing it out there that if you pulled the lid off those SSRs you're buying there's likely a MOSFET or TRIAC inside. https://en.wikipedia.org/wiki/Solid-state_relay#Operation (Would have just posted but Waldo's a little cranky lately on resurrecting old threads.)
    1. mark tomlinson likes this.
  6. billyo harmon
  7. zerrone
  8. Obkov
  9. Mr Wire
    Mr Wire
    Im new using a Robo3D R1 Plus
  10. bloastp blasto
  11. heloako
  12. Gene Arguelles
  13. worknew
  14. jim knocke
    jim knocke Harry
    Harry, I am trying to replace my extruder nozzle on a Roibo 3d R1 Plus and what I read is not clear. cannot find a release screw. Help
  15. wthierry
  16. KellywithaY
    KellywithaY
    "UNSCREW ALL THE SCREWS!"
  17. jim knocke
    jim knocke
    robo3 extruder nozzle gets clogged, help?
  18. mclemens7
    mclemens7 Mike Kelly
    I am using your latest design for the dual extruders for the r1 plus on Thingiverse. I do not know how to add the two fans for cooling the heat sink? any ideas
    1. View previous comments...
    2. mclemens7
      mclemens7
      what do you mean, how would i attach it to the heatsink?
      May 10, 2017
    3. Mike Kelly
      Mike Kelly
      You don't need all 4, just one of the corners then it can fit
      May 12, 2017
    4. mclemens7
      mclemens7
      Do I have to 3d print anything else. I don't understand where I put the actual fan
      May 12, 2017
  19. Gripp
    Gripp
    Just ordered a Robo 3D R1 plus.
  20. ReeCoupons
    ReeCoupons
    Online Coupons and Discounts offers are offered.