New Profile Posts

If you are mistake regarding Mark Edwards's Power Efficiency Guide then pay a visit to my web site at http://powerefficiencybook.com/

Could you help me with my robo r1 IR sensor install? Thank you !

Do you have the configuration H file for your robo r1+ with the ir sensor?

Mark, my printer stops printing after about 20 minutes. R1+ Matter Control Windows 8.1 from a lap top. After I walk away and return and wake the lap top, Matter Control page says in the top left corner printer not communicating. Any thoughts?

Hi Jess
Thanks for the link. Clicking on does not open the image.
What have I done wrong

Eeon

7th grade science teacher, 3D printing novice

Mr WheresWaldo,
If I remember correctly you have or had a Creator Pro? Today, what ever I set the heatbed to, it is always defaulting to 120. Even if I set the heatbed to 0 in Simplify3d. I turned the preheat settings to 0 and turned the bed off in preheat. I even tried older prints that I've successfully printed in the past and it still defaults to 120 during preheat.

Echo:Cold Extrusion Prevented ?

Hi Mike,
I am looking for information on swapping my thermistor to a type k thermocouple. I can find info on the pt100 but nothing for the type k. If you know anything please let me know.

Hi Mark,

I was hoping to find some information about switching my thermistor to the Type K thermocouple. I can find a lot of information on the pt100 but nothing on the type K. Any info would be appreciated.

I'm getting an Error Detected - MAXTEMP triggered, system stopped! Heater_ID: 0

ok I got it the boot on hot end was missing

I found the problem it was therubber boot that goes on hot end

ERROR EXTRUDER SWITCHED OFF/MAXTEMP TRIGERED

The best Happy Diwali Messages In Hindi and Wishes. http://diwaliimages2018.site

Busy busy... Top secret stuff ;) ;)

#Purefit Keto Weight Loss Pills www.wellnesscarezone.com/purefit-keto-reviews/

Looking for help.

Hi there, saw one of your posts about creating 3D human scans using Trnio app. We need a job work to be accomplished using Trnio/Scann3D, can you help us?