Here the community can post and only post pre-vetted and community approved recommendations for improvements or changes to the C2 3d Printer. Thu, 16 Jul 2026 22:55:28 +0000 Thu, 16 Jul 2026 22:55:28 +0000 ROBO 3D User Forum http://community.robo3d.com/index.php?forums/community-recommendations.88/ Fri, 22 Jun 2018 15:15:15 +0000 http://community.robo3d.com/index.php?threads/improvement-for-the-c2-and-r2-printers.21406/ http://community.robo3d.com/index.php?threads/improvement-for-the-c2-and-r2-printers.21406/ invalid@example.com (tkoco) tkoco
Suggestion: Use a perforated cover plate to allow the cooling air to flow through it, but still protect fingers from touching the hot end.]]> 1 Thu, 19 Oct 2017 18:14:29 +0000 http://community.robo3d.com/index.php?threads/my-general-recommendations-for-the-c2.19630/ http://community.robo3d.com/index.php?threads/my-general-recommendations-for-the-c2.19630/ invalid@example.com (OutsourcedGuru) OutsourcedGuru
* The location of the C2's single filament spool holder is too high, leading to cross-over spooling problems. I would suggest lowering the spindle hole as low as possible on the back. Secondly, the way the holder fits in the hole is problematic, leading to drop-outs during a job with a full KG spool. I...

My general recommendations for the C2]]> 2 Wed, 18 Oct 2017 19:51:46 +0000 http://community.robo3d.com/index.php?threads/what-this-area-is-about.19628/ http://community.robo3d.com/index.php?threads/what-this-area-is-about.19628/ invalid@example.com (mark tomlinson) mark tomlinson
This is not and should not be for complaints or gripes.
It should be for constructive ideas that perhaps the Robo Team has not thought about.
It can't be just "I want this" or "It needs to have that" without an explanation about why or how it could help performance or print quality. Detailed explanations of what the improvement is and why it adds value are what we are after.

Spurious posts will be...

What this area is about]]> 1