1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

X & Y axis issues

Discussion in 'Mods and Upgrades' started by joshua cheers, Aug 20, 2018.

  1. joshua cheers

    joshua cheers New Member

    Joined:
    Jul 25, 2015
    Messages:
    10
    Likes Received:
    1
    #1 joshua cheers, Aug 20, 2018
    Last edited: Aug 20, 2018
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    How are you printing (from a PC or from an SD card)?
    Does it recover at some point or continues doing this?
     
  3. joshua cheers

    joshua cheers New Member

    Joined:
    Jul 25, 2015
    Messages:
    10
    Likes Received:
    1
    Printing from computer, it doesn’t recover just stays like this and makes a mess of the print that’s already on the bed
     
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Try printing from the SD card and see if it continues, you can still launch the print and monitor it from the PC but that eliminates USB communications problems.
     
  5. joshua cheers

    joshua cheers New Member

    Joined:
    Jul 25, 2015
    Messages:
    10
    Likes Received:
    1
    I tried to print the off the sd card using the same firmware, same issue no indications to state a fault.
    the printer was working great until yesterday when i changed firmware to switch over to the titan extruders.
     
  6. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Well there is a rather important chunk of data you should have started with.
    Not sure that I have any advice to offer since I don't use that extruder and can't really address issues with that.
    Rolling back to the original / stock firmware would be a test to see if it changes back to the original behavior or not.
    Eliminate that as a contender.
     

Share This Page