1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Robo 3D R2 Does not start

Discussion in 'Troubleshooting' started by Alvin Jacob, Sep 12, 2019.

  1. Alvin Jacob

    Alvin Jacob New Member

    Joined:
    Sep 12, 2019
    Messages:
    13
    Likes Received:
    3
    Hi,

    My R2 printer is not starting when I switch it on from the back button.
    By not starting I mean, no display, the fans don't turn on as they are supposed to.

    Please Help!!
     
    #1 Alvin Jacob, Sep 12, 2019
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Moved this from the R1 section to the R2 section.
     
    #2 mark tomlinson, Sep 12, 2019
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Does the power supply brick have 24v DC coming out of it?
     
    #3 mark tomlinson, Sep 12, 2019
  4. Alvin Jacob

    Alvin Jacob New Member

    Joined:
    Sep 12, 2019
    Messages:
    13
    Likes Received:
    3
    Yes.
    Over removing the bottom cover, found that the fuse is blown. Will replace it with a new one.
    I believe that will solve the problem. Hoping for the best.
     
    #4 Alvin Jacob, Sep 12, 2019
    mark tomlinson likes this.
  5. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    721
    Likes Received:
    273
    Would not surprise me. I have seen fuses go bad due to manufacturing problems and not from electrical overloads.
     
    #5 tkoco, Sep 12, 2019

Share This Page