1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Working Cura versions

Discussion in 'Software' started by Lance Weston, Apr 22, 2020.

  1. Lance Weston

    Lance Weston Active Member

    Joined:
    Jun 2, 2018
    Messages:
    664
    Likes Received:
    230
    Moved to Software - admin

    Probably the wrong place but I do not know where it should go.



    Version 4.4 was the last version that had retraction enabled. 4.5 and 4.6 have no retraction.
     
    #1 Lance Weston, Apr 22, 2020
    Last edited by a moderator: Apr 23, 2020
  2. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    721
    Likes Received:
    273
    You need to re-enable all options: Preferences -> Configure Cura -> Settings & check the Check all box.

    The Retraction control settings have been moved to the Travel area of a profile.
     
  3. Lance Weston

    Lance Weston Active Member

    Joined:
    Jun 2, 2018
    Messages:
    664
    Likes Received:
    230
    Thanks, I hate it when then move stuff around and I can't find it.
    Over half of the options are greyed out "This setting has been hidden by the active machine and will be greyed out".
     
  4. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    721
    Likes Received:
    273
    Evidently some of the settings are dependent on other setting being activated.
     

Share This Page