1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Couple of Prints

Discussion in 'Projects' started by cosber, Jun 26, 2015.

  1. cosber

    cosber Active Member

    Joined:
    Jun 20, 2013
    Messages:
    300
    Likes Received:
    87
    I had a clogged nozzle and spent 2 weeks off and on trying to clear it. Finally got it clear without tearing it apart. Here are some fruits of my labor.

    image.jpg image.jpg
     
    kameya and Mike Kelly like this.
  2. janot928

    janot928 Active Member

    Joined:
    Feb 20, 2015
    Messages:
    276
    Likes Received:
    40
    nice print quality. bty hoy did you uncloged your noozle? i have an E3D V6 0.4mm noozle witch is complitly clogged with abs
     
  3. Joe H

    Joe H Member

    Joined:
    Dec 10, 2014
    Messages:
    32
    Likes Received:
    18
    there are a few threads in the troubleshooting section as to clearing clogs.
     
  4. cosber

    cosber Active Member

    Joined:
    Jun 20, 2013
    Messages:
    300
    Likes Received:
    87
    It turned out not to be a clog-the head was bad. Robo switched it out for me. Don't know exactly what was bad about it, but that's my story and I'm sticking to it!
     

Share This Page