Unanswered MatterControl First layer quality

So as far as I've been able to manage, I havent yet found the setting for creating a nice smooth first layer using the mattercontrol slicer as is possible with cura.
I'd really like to know how to do this because there are some print's that mattercontrol prints better for than Cura and it would be nice if I could get that nice flat surface on the bottom too.
Does anyone know of a setting or way to do that?

Thanks

 

I looked this, I helped me a lot.

 

Hey, I had issues, the way to change it is by using the macros setting, if there is too large of a gap, increase the number, too small, do the oppisite. Also, make sure your bed is placed in the magnets so its mostly flat or this setting change may not help. However, I hope this helps you out!