1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by 1stgenbrz

  1. 1stgenbrz
    Post

    Solved Robo3d R1+ heated bed

    After trying a new RAMPS board to no avail, turns out it was just the hot end thermistor...
    Post by: 1stgenbrz, Apr 16, 2020 in forum: Troubleshooting
  2. 1stgenbrz
    Post

    Solved Robo3d R1+ heated bed

    Could the power surge have fried the arduino?
    Post by: 1stgenbrz, Mar 29, 2020 in forum: Troubleshooting
  3. 1stgenbrz
    Post

    Solved Robo3d R1+ heated bed

    yes I did. I didnt test them electrically, but visually, nothing out of the ordinary. Upon testing, there were times when both thermistor...
    Post by: 1stgenbrz, Mar 29, 2020 in forum: Troubleshooting
  4. 1stgenbrz
    Post

    Solved Robo3d R1+ heated bed

    I opened up the bottom cover to check whats been going on. All the contacts seem ok, everything plugged in. But, I still cannot get any prints...
    Post by: 1stgenbrz, Mar 29, 2020 in forum: Troubleshooting
  5. 1stgenbrz
    Thread

    Solved Robo3d R1+ heated bed

    After years of faithful service, the original heated bed on my R1+ might be on its way out. I get the error message "Err: TEMP FALL ERROR" on my...
    Thread by: 1stgenbrz, Mar 28, 2020, 11 replies, in forum: Troubleshooting