Recent Content by Amanda Galiano

Post

Thank you all! It appears to be working again! I really thought it had something to do with the fan or something since there wasn't a place on the...

Post by: Amanda Galiano, May 15, 2019 in forum: Troubleshooting

Thread

I had some filament stuck and it looks like my print head fell apart. The black rubber part came off, and that's easy enough to stick back, but...

Thread by: Amanda Galiano, May 14, 2019, 5 replies, in forum: Troubleshooting

Post

I might have found the issue. There was a magnet that was a few mms offset. It wasn't that noticeable to the eye, and I wouldn't have thought...

Post by: Amanda Galiano, May 2, 2017 in forum: Troubleshooting

Post

Here's what it did to the print bed on my first print.

Post by: Amanda Galiano, May 2, 2017 in forum: Troubleshooting

Thread

I have a Robo 3d R1+ that I love (and two other 3d printers, so I'm not a total newbie. The Robo is most basic one). I just got a Robo C2 and I...

Thread by: Amanda Galiano, May 2, 2017, 4 replies, in forum: Troubleshooting

Post

I did not remove the screws. I'll look up how to do that and give it a try. I think if I could open the feed, I could grab it (I know which...

Post by: Amanda Galiano, Sep 3, 2016 in forum: Troubleshooting

Thread

I searched for threads on this, but all I found is filament stuck between the wheel and extruder. It's probably because I don't know the name of...

Thread by: Amanda Galiano, Sep 2, 2016, 5 replies, in forum: Troubleshooting