1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by AndyDittmar

  1. AndyDittmar
    Post

    Problems running Cura on robo R1

    It’s every print. It doesn’t matter on the stl file. It would be more useful to send the gcode so you can see it that way.
    Post by: AndyDittmar, Jan 3, 2018 in forum: Software
  2. AndyDittmar
    Post

    Problems running Cura on robo R1

    It’s not the settings I don’t like. It’s the interface. But back to the original question. Does anyone have any idea how to fix this under...
    Post by: AndyDittmar, Dec 23, 2017 in forum: Software
  3. AndyDittmar
    Post

    Problems running Cura on robo R1

    .4 I double checked settings like that just to make sure. 3.1 is just fumbly for me I like 15.
    Post by: AndyDittmar, Dec 23, 2017 in forum: Software
  4. AndyDittmar
    Post

    Problems running Cura on robo R1

    Layer overlap is 15% like the other programs. It's like it has the wrong extruder speed, but I can't find anywhere what that should be, or how to...
    Post by: AndyDittmar, Dec 18, 2017 in forum: Software
  5. AndyDittmar
    Post

    Problems running Cura on robo R1

    [ATTACH] [ATTACH] [ATTACH] The white swatch was using MatterControl the others are Cura
    Post by: AndyDittmar, Dec 16, 2017 in forum: Software
  6. AndyDittmar
    Thread

    Problems running Cura on robo R1

    Hey everyone, I have been using my R1+ for a while and recently installed a controller (XXL) on it. everything runs fine from the matter control...
    Thread by: AndyDittmar, Dec 16, 2017, 11 replies, in forum: Software