1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by charles Page

  1. charles Page
    Post

    Unresolved Power mystery

    Awesome. I just installed a new power supply and that seemed to help. I'll check the fan. Thank you!
    Post by: charles Page, Mar 24, 2016 in forum: Troubleshooting
  2. charles Page
    Post

    Unresolved Power mystery

    So it may be overheating? Hmmm. Ill check it. Thanks!
    Post by: charles Page, Mar 24, 2016 in forum: Troubleshooting
  3. charles Page
    Post

    Do you watch your prints being made?

    The mesmerizing factor hasn't worn off yet. It's quite accidental. I will want to watch a particular part print or start and three hours later,...
    Post by: charles Page, Mar 24, 2016 in forum: Off Topic
  4. charles Page
    Post

    Unresolved Power mystery

    Yes, lights go out, motors start jerking (the x axis specifically), in the communication screen on s3d it says that there was an error and to use...
    Post by: charles Page, Mar 24, 2016 in forum: Troubleshooting
  5. charles Page
    Post

    Unresolved Power mystery

    Well, no luck. I did complete a 5 hour print but during another print last night and one this morning the issue came back. Any help would be...
    Post by: charles Page, Mar 24, 2016 in forum: Troubleshooting
  6. charles Page
    Post

    Unresolved Power mystery

    Well, I feel like a dummy. The new power supply was not on 110v. I switched it and am powering up now. Seems to have fixed the issues. I will...
    Post by: charles Page, Mar 23, 2016 in forum: Troubleshooting
  7. charles Page
    Thread

    Unresolved Power mystery

    Hey guys. So I got my printers (I bought 2 of the r1+ for my classroom)mid december and have been printing non stop. I'm using simplify 3d and...
    Thread by: charles Page, Mar 23, 2016, 10 replies, in forum: Troubleshooting