1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Commodore323863

  1. Commodore323863
    Post

    Partially Solved Bed temperature reading stuck at 100°C

    It's been a while. A few months ago I bought the generic RAMPS 1.4 board, and went ahead with the board conversion steps, only to find that the...
    Post by: Commodore323863, Jun 10, 2025 in forum: Troubleshooting
  2. Commodore323863
    Post

    Partially Solved Bed temperature reading stuck at 100°C

    Upon some off-printer testing, I could determine that the circuit responsible for sensing the bed thermistor is damaged in some way. I used some...
    Post by: Commodore323863, Nov 21, 2024 in forum: Troubleshooting
  3. Commodore323863
    Post

    Partially Solved Bed temperature reading stuck at 100°C

    I have taken the RAMPS and the Arduino board completely off the printer for a better visual inspection, aside from the overheated pin, nothing...
    Post by: Commodore323863, Nov 20, 2024 in forum: Troubleshooting
  4. Commodore323863
    Thread

    Partially Solved Bed temperature reading stuck at 100°C

    Hey there. My 3D printer (Robo R1+) reports 105°C present on the heated bed, as it is on room temperature (in both Cura and MatterControl), but...
    Thread by: Commodore323863, Nov 19, 2024, 6 replies, in forum: Troubleshooting