1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Dave Telling

  1. Dave Telling
    Post

    How to Update and Edit Robo firmware with Arduino

    At this point, I'm going back to PLA for some projects. I'm frankly disappointed by the Robo website that says that ABS can be printed, but gives...
    Post by: Dave Telling, Jan 26, 2017 in forum: Software
  2. Dave Telling
    Post

    How to Update and Edit Robo firmware with Arduino

    Mine shut down printing with an over temp error when I set the bed temp to 110C. I don't know how old the printer is, I got it from a relative....
    Post by: Dave Telling, Jan 26, 2017 in forum: Software
  3. Dave Telling
    Post

    How to Update and Edit Robo firmware with Arduino

    I'd say that is an understatement! :D
    Post by: Dave Telling, Jan 26, 2017 in forum: Software
  4. Dave Telling
    Post

    How to Update and Edit Robo firmware with Arduino

    I'd like to be able to modify parameters if necessary, specifically max temps for the bed when printing ABS. I know, I know - I shouldn't be using...
    Post by: Dave Telling, Jan 26, 2017 in forum: Software
  5. Dave Telling
    Post

    How to Update and Edit Robo firmware with Arduino

    Here is an example of the warning: In file included from C:\Users\Dave\AppData\Local\Temp\arduino_build_753685\sketch\Marlin.h:23:0, from...
    Post by: Dave Telling, Jan 26, 2017 in forum: Software
  6. Dave Telling
    Post

    How to Update and Edit Robo firmware with Arduino

    Mark, I did the edits the article discussed. That seemed to allow the compilation to proceed. However, I still get warnings about X_Max, Y_MAX,...
    Post by: Dave Telling, Jan 26, 2017 in forum: Software
  7. Dave Telling
    Post

    How to Update and Edit Robo firmware with Arduino

    What is the editing required? I have done a number of Arduino-based projects, so I have some familiarity with how to use the IDE.
    Post by: Dave Telling, Jan 26, 2017 in forum: Software
  8. Dave Telling
    Post

    How to Update and Edit Robo firmware with Arduino

    Mark and Waldo - I am new to 3D printing, and this is the first printer I have owned. I have been having problems printing ABS, and was hoping...
    Post by: Dave Telling, Jan 26, 2017 in forum: Software
  9. Dave Telling
    Post

    How to Update and Edit Robo firmware with Arduino

    I cannot get any update to work. If I try to use the hex file for use with Matter Control, I save the link as a hex file. I then go to the Matter...
    Post by: Dave Telling, Jan 25, 2017 in forum: Software
  10. Dave Telling
    Post

    Solved Removing bed plate and fixing y-axis

    I just read this thread, as I was wondering how the bed came up, and so thanks to all who contributed. It was also timely to read about the...
    Post by: Dave Telling, Jan 23, 2017 in forum: Troubleshooting