1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Day Vid

  1. Day Vid
    Post

    3D Solutech Glow In Dark 3D Printer PLA Filament

    OK, I finally think I have the settings dialed in for this filament, and I though I would share them here in case anyone else wants to use it. It...
    Post by: Day Vid, Nov 26, 2017 in forum: Filament
  2. Day Vid
    Thread

    Cooling upgrade

    This being my first printer I will disclaim that I do not know what I'm talking about. That being said, I suspect most of the quality issues I am...
    Thread by: Day Vid, Nov 20, 2017, 4 replies, in forum: Troubleshooting
  3. Day Vid
    Post

    Hole in rocket on the nose

    Would it be possible for you to send me the g code file you made with Simplify 3d? If I can get it to print then I can confirm it's a settings issue.
    Post by: Day Vid, Nov 19, 2017 in forum: Troubleshooting
  4. Day Vid
    Post

    Hole in rocket on the nose

    That's what I suspected. I've tried doing several things to mitigate; all yielded no benefit. I turned cooling fans up, spend more time over the...
    Post by: Day Vid, Nov 19, 2017 in forum: Troubleshooting
  5. Day Vid
    Thread

    Hole in rocket on the nose

    I've tried printing this rocket twice. Both times I used the sprialize option in Cura. The second time I slowed down the print but it didn't...
    Thread by: Day Vid, Nov 18, 2017, 7 replies, in forum: Troubleshooting
  6. Day Vid
    Thread

    gcode files missing from R2 console

    When I first got my R2 I ran a test print before updating. Then I updated and I noticed some of the example files stored on the machine were...
    Thread by: Day Vid, Nov 17, 2017, 2 replies, in forum: Troubleshooting
  7. Day Vid
    Post

    PEI Print Bed Problem

    I scratched up my bed pretty good not knowing any better. I found that the adhesion on my bed didn't work very well anyway. I ended up sanding...
    Post by: Day Vid, Nov 17, 2017 in forum: Troubleshooting
  8. Day Vid
    Post

    PID tuning and Marlin

    I was able to tune the hotend ok, but I've tried the bed several times and it times out during the cycle.
    Post by: Day Vid, Nov 17, 2017 in forum: General Questions
  9. Day Vid
    Post

    Cura 3.0

    The thing I've noticed is that on the R2 itself I get a crazy estimate. For example, Cura may say 7 hours. When I load it it and print it the R2...
    Post by: Day Vid, Nov 17, 2017 in forum: Software
  10. Day Vid
    Post

    Are People Having Success?

    Thank you
    Post by: Day Vid, Nov 16, 2017 in forum: General Questions
  11. Day Vid
    Post

    Are People Having Success?

    I'm willing to concede that my expectations were probably unrealistic. My point with the CR-10 was that if I have to put this amount of work...
    Post by: Day Vid, Nov 16, 2017 in forum: General Questions
  12. Day Vid
    Post

    Are People Having Success?

    I have to say although I respect your here,comparing it to experiences with all other printers it's not really valid when this printer was touted...
    Post by: Day Vid, Nov 16, 2017 in forum: General Questions