Recent Content by Emily Finan

Post

yeah, it was brittle filament (very end of a roll that wasn't brittle before, but is now that I'm towards the end. It went in the recycle bin.)

Post by: Emily Finan, Feb 24, 2025 in forum: Troubleshooting

Post

Yeah, Unfortunately that is not where the filament is stuck. It is stuck up in the tube where the filament is stored before going into the hot...

Post by: Emily Finan, Feb 24, 2025 in forum: Troubleshooting

Thread

I have a short piece of filament stuck in the tube between the hot end and the extruder. I've had jams that I've been able to pull out, but this...

Thread by: Emily Finan, Feb 24, 2025, 7 replies, in forum: Troubleshooting