1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Gary Fellows

  1. Gary Fellows
    Post

    Flattened Tessellations

    Considering l am only 1.5 weeks into 3D printing and with the tips and tricks of you guys, l am making progress, slowly. Maybe what l am trying...
    Post by: Gary Fellows, Oct 18, 2017 in forum: General Questions
  2. Gary Fellows
    Post

    Flattened Tessellations

    Geof, I have applied a Z hop over printed parts now and altered the default Z Hop Height of 0.075mm to 0.5mm and shall try this. Regarding your...
    Post by: Gary Fellows, Oct 18, 2017 in forum: General Questions
  3. Gary Fellows
    Thread

    Flattened Tessellations

    How can l prevent a smallish tessellated print from having a flattened peak, refer to image.[ATTACH]
    Thread by: Gary Fellows, Oct 18, 2017, 6 replies, in forum: General Questions
  4. Gary Fellows
    Thread

    0.4mm to 0.2mm Nozzle

    How easy is it to change a 0.4mm supplied nozzle to a 0.2mm nozzle? Easy? Any negatives?
    Thread by: Gary Fellows, Oct 17, 2017, 3 replies, in forum: General Questions
  5. Gary Fellows
    Thread

    Dull Print Bed

    Robo R2 I have is 1 week old. Shiny bed is shiny no more. Used flat scraper over 6 or 7 prints and shine gone. Looks awful, but is this a problem?
    Thread by: Gary Fellows, Oct 16, 2017, 3 replies, in forum: Troubleshooting
  6. Gary Fellows
    Post

    Sticking Prints

    I shall try what you suggest.
    Post by: Gary Fellows, Oct 16, 2017 in forum: Troubleshooting
  7. Gary Fellows
    Thread

    Sticking Prints

    I have been using R2 for 1 week, with a rollercoaster of a ride. On day 1, the scraper within the box pretty much ruined the bed surface....
    Thread by: Gary Fellows, Oct 16, 2017, 3 replies, in forum: Troubleshooting
  8. Gary Fellows
    Post

    Lumpy Bumpy Print Finish Near End of Print

    Hi Mechanixfronti. I have taken the advice, and reduced the print speed. This resulted in a satisfactory print.
    Post by: Gary Fellows, Oct 15, 2017 in forum: General Questions
  9. Gary Fellows
    Post

    Lumpy Bumpy Print Finish Near End of Print

    I can't recall seeing if I can set top thickness using Cura. I'll check tomorrow.
    Post by: Gary Fellows, Oct 13, 2017 in forum: General Questions
  10. Gary Fellows
    Post

    Lumpy Bumpy Print Finish Near End of Print

    I think the fan is 75% eek Speed 50mm/ These were supplied by Colorfabb this week. Many thanks. I know what I'm tomorrow.
    Post by: Gary Fellows, Oct 13, 2017 in forum: General Questions
  11. Gary Fellows
    Post

    Lumpy Bumpy Print Finish Near End of Print

    Nozzle 230C, bed 70C. Middle of range and recommended by Colorfabb earlier this week. Tomorrow, l shall bring Z down by 0.05mm.
    Post by: Gary Fellows, Oct 13, 2017 in forum: General Questions