Separate names with a comma.
Bed crashing into the nozzle = ir sensor not actuated, if your offset is less than the min read distance in the IR firmware settings it seems to...
I don’t think I understand, can you post some pictures and a video of what’s goin on
that’s where the dollars I don’t have to too ;) :p
If I had a dollar for every time I’ve done similar :)
Might want to try another less involved slicer for dual extrusion
I’d guess the beeping is a safety warning as well. Likely wired wrong. I have a spare original loud as shit power supply you can have for the...
Check out those categories on my myminifactory.com thingiverse.com etc.
I believe all sales have moved to their my stem kits site and the Robo site is there just because
Interesting, which part specifically did you replace and can you add a photo ? First I’ve Heard of that issue
Yes but going into the R1 with the r2 C2 doesn’t go so good
When mine reboots it shows the error briefly then reboots to try to correct the issue and prevent damage. Yours did not so this ?
I won’t be much help. I manually level my bed- set the offset from the menu and all that’s in my g code is G28 - home all a is. Octoprint is empty
You certainly can.... but if it fell apart once... is it worth your time ? I’d get the c2 hotend and put your heater and thermistor in it
I did this as a trial- it’s a no go if you need to go past 220 :(
If all you need is the metal bits you can. If you want the heater and thermistor NO.