1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Jeff Hamilton

  1. Jeff Hamilton
    Post

    Unresolved Print head not raising at end of print

    Thank you very much. I knew I was missing something but I couldn't figure it out. Most of my parts are short so the 30mm lift worked, now with the...
    Post by: Jeff Hamilton, Apr 29, 2021 in forum: Troubleshooting
  2. Jeff Hamilton
    Thread

    Unresolved Print head not raising at end of print

    I am really confused. My print head is dropping by about 1mm at the end of the print and damaging the print rather than raising up before moving....
    Thread by: Jeff Hamilton, Apr 29, 2021, 2 replies, in forum: Troubleshooting
  3. Jeff Hamilton
    Post

    Solved Printer not responding

    Well it did end up being that I had uploaded a program I was working on to the 3d printer. It was real fun re-installing everything since I had...
    Post by: Jeff Hamilton, Jun 12, 2018 in forum: Troubleshooting
  4. Jeff Hamilton
    Post

    Solved Printer not responding

    The printer was not plugged in while I was working on another project. What do I look at to see if the board went bad?
    Post by: Jeff Hamilton, Jun 12, 2018 in forum: Troubleshooting
  5. Jeff Hamilton
    Thread

    Solved Printer not responding

    Went to use my printer today after a couple of weeks and when I start Mattercontrol and try to connect it says "Invalid Printer Response" and...
    Thread by: Jeff Hamilton, Jun 12, 2018, 4 replies, in forum: Troubleshooting
  6. Jeff Hamilton
    Post

    Answered ABS barrel print problems

    Got the larger section to print better, but the small top section would always turn out muddy even though I slowed it down. So I gave up and...
    Post by: Jeff Hamilton, Feb 21, 2018 in forum: Troubleshooting
  7. Jeff Hamilton
    Post

    Answered ABS barrel print problems

    That helped a little on the top but the seem in the side got worse. Going to try and randomize the start points as Mark suggested and drop temp to 225
    Post by: Jeff Hamilton, Feb 21, 2018 in forum: Troubleshooting
  8. Jeff Hamilton
    Thread

    Answered ABS barrel print problems

    I am using S3D to print this 12mm x 21mm tall hollow barrel and I can't seem to figure out what I am doing wrong. I am printing at 230 with a 90c...
    Thread by: Jeff Hamilton, Feb 21, 2018, 5 replies, in forum: Troubleshooting
  9. Jeff Hamilton
    Post

    Solved PETG filament adjustment suggestions

    Changed to the 910 and after several attempts working with the supports and the temp I finally got it right. I had the temp at 250 when I tried...
    Post by: Jeff Hamilton, Feb 20, 2018 in forum: Troubleshooting
  10. Jeff Hamilton
    Post

    Solved PETG filament adjustment suggestions

    Thank you, I'll give it a try.
    Post by: Jeff Hamilton, Feb 19, 2018 in forum: Troubleshooting
  11. Jeff Hamilton
    Post

    Solved PETG filament adjustment suggestions

    Mark, I have some 910 would you share your setting so I can give that a try?
    Post by: Jeff Hamilton, Feb 19, 2018 in forum: Troubleshooting
  12. Jeff Hamilton
    Post

    Solved PETG filament adjustment suggestions

    Thank you. I didn't fully understand what you wrote, but I got it now. I have been slowly making changes to make improvements but I haven't hit...
    Post by: Jeff Hamilton, Feb 19, 2018 in forum: Troubleshooting