1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by jhenager1

  1. jhenager1
    Post

    Solved Stopped printing from SD card

    I have a newed appreciation for the Robo after struggling with the knockoff Kossel I got. They are sending me another mainboard, but compared to...
    Post by: jhenager1, Dec 2, 2016 in forum: Troubleshooting
  2. jhenager1
    Post

    Solved Stopped printing from SD card

    It might be bad form to reply to myself on a Solved thread but I am so excited that I got the strange problem figured out and then got brave in...
    Post by: jhenager1, Dec 2, 2016 in forum: Troubleshooting
  3. jhenager1
    Post

    Solved Stopped printing from SD card

    Post by: jhenager1, Dec 2, 2016 in forum: Troubleshooting
  4. jhenager1
    Post

    Solved Stopped printing from SD card

    Yes.
    Post by: jhenager1, Oct 26, 2016 in forum: Troubleshooting
  5. jhenager1
    Post

    Solved Stopped printing from SD card

    Hey, thanks for the advice. I really do plan on giving the LCD controller another go, but right now, I need to keep printing. What I did was...
    Post by: jhenager1, Oct 26, 2016 in forum: Troubleshooting
  6. jhenager1
    Post

    Solved Stopped printing from SD card

    Yes, bed and extruder heat up fine, and am printing a part right now. SD card reader just quits after about 1-2 seconds. I also noticed I have...
    Post by: jhenager1, Oct 26, 2016 in forum: Troubleshooting
  7. jhenager1
    Post

    Solved Stopped printing from SD card

    Yes, this is the stock card reader. I do have an LCD that I might try to setup. Thanks.
    Post by: jhenager1, Oct 25, 2016 in forum: Troubleshooting
  8. jhenager1
    Thread

    Solved Stopped printing from SD card

    Yesterday, I went to print the final part of a 31 piece assembly, and noticed it did not start heating up the bed after 4 seconds like it has been...
    Thread by: jhenager1, Oct 25, 2016, 18 replies, in forum: Troubleshooting
  9. jhenager1
    Thread

    What model NEMA 17 stepper motor should I get?

    I'm putting together a replacement extruder assembly and want to do a direct swap in case I need to go back to the original, but did not realize...
    Thread by: jhenager1, Sep 2, 2016, 7 replies, in forum: Mods and Upgrades
  10. jhenager1
    Thread

    Looking for a used stock X-carriage

    My hotend will no longer stay in the extruder holder due to the very poor design of having metal screws secured in plastic. After several...
    Thread by: jhenager1, Aug 11, 2016, 4 replies, in forum: Mods and Upgrades
  11. jhenager1
    Thread

    Printing replacement stock hotend part

    Does anyone have a STL for the part right on top that has the two springloaded screws? I have worn a big hole in one side. I think I can fix it...
    Thread by: jhenager1, Jul 30, 2016, 1 replies, in forum: Mods and Upgrades