1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Justin Riera

  1. Justin Riera
    Post

    Unresolved I dont even know...

    Thanks. I might actually be going to orlando sometime this summer but then again im still a teenager so it all comes down to my parents. Today I...
    Post by: Justin Riera, Jun 24, 2016 in forum: Troubleshooting
  2. Justin Riera
    Thread

    Unresolved I dont even know...

    I havent been able to use my printer in months. Me being lazy and unorganized, My R1+ became a disaster. I dont even know whats going on i just...
    Thread by: Justin Riera, Jun 23, 2016, 6 replies, in forum: Troubleshooting
  3. Justin Riera
    Post

    Unresolved Prints in air.

    That's what I was hoping it was. They told me to adjust the brackets and that is not the problem X-maxx Jato 3.3 Ford raptor F-150
    Post by: Justin Riera, Feb 18, 2016 in forum: Troubleshooting
  4. Justin Riera
    Thread

    Unresolved Prints in air.

    I adjusted the brackets and the threaded rods, but when I start a print, it moves back up and prints high in the air. X-maxx Jato 3.3 Ford raptor...
    Thread by: Justin Riera, Feb 15, 2016, 4 replies, in forum: Troubleshooting