Recent Content by Kurt Kadow

Post

Thanks for all the replies I was concerned about the USB not getting the right amount of signal. I will be looking into all your suggestions....

Post by: Kurt Kadow, May 6, 2017 in forum: General Questions

Thread

Does it matter how far I run the printer cord from my PC to my R1+ i want to move my printer to my hobby room that is about 40 ft away I wanted to...

Thread by: Kurt Kadow, May 5, 2017, 5 replies, in forum: General Questions

Post

Yes but it seems to not be using about 2 inches of heated build area and is trying to print on the unheated area I'm just trying to move the print...

Post by: Kurt Kadow, Jul 25, 2016 in forum: Troubleshooting

Post

Yes I can move it around however even after moving and saving it still prints to far up the build plate almost like the center is off.

Post by: Kurt Kadow, Jul 25, 2016 in forum: Troubleshooting

Thread

Ok I have read all the threads about the plate and graphic do not mean that's your print area but when I print an object it prints to far up on...

Thread by: Kurt Kadow, Jul 25, 2016, 5 replies, in forum: Troubleshooting

Thread

I want to make the Baby Sword Axe and Mace from thingiverse. My question is the extruders brass tip I have heard that lead is used in the process...

Thread by: Kurt Kadow, Jun 1, 2016, 2 replies, in forum: Projects