1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by momoe

  1. momoe
    Post

    Solved Y-axis belt with connectors

    I seem to have broken the connector that holds the y-axis belt to the base plate carriage. It’s what the bolt screws into. I figured the belt...
    Post by: momoe, Jan 4, 2020 in forum: Troubleshooting
  2. momoe
    Thread

    Solved Y-axis belt with connectors

    where is a good source to buy parts for this old R1? my connector that holds the Y-axis belt to the bed rails broke off today.. I went on Robo3d...
    Thread by: momoe, Jan 4, 2020, 5 replies, in forum: Troubleshooting
  3. momoe
    Post

    Solved Heat sink mounting issues

    A little dremel action and now we are good to go
    Post by: momoe, Dec 31, 2019 in forum: Troubleshooting
  4. momoe
    Post

    Solved Heat sink mounting issues

    It’s the R1. I got this the year they released them. I think I got a new part that holds the motor and extruded and I think they sent me the R1+...
    Post by: momoe, Dec 31, 2019 in forum: Troubleshooting
  5. momoe
    Post

    Solved Heat sink mounting issues

    It’s been so long I don’t remember what I’ve replaced on this or not. If I replaces the part that connects to the heat sink, could it be wrong?...
    Post by: momoe, Dec 31, 2019 in forum: Troubleshooting
  6. momoe
    Post

    Solved Heat sink mounting issues

    Ok. I don’t get it. I got the heat sink from matter hackers. It does the same thing. The screws that cross through the extruded to hold it in...
    Post by: momoe, Dec 31, 2019 in forum: Troubleshooting
  7. momoe
    Post

    Solved Heat sink mounting issues

    Yeah. That was a Biden adapter I removed and tried again but I think this was an amazon special I ordered. I went to matterhackers and got the...
    Post by: momoe, Dec 28, 2019 in forum: Troubleshooting
  8. momoe
    Post

    Solved Heat sink mounting issues

    https://www.matterhackers.com/store/l/e3d-v6-heat-sink-1.75mm/sk/MF0S9M79 Would this be the one I need to fit the stock carriage of the R1?
    Post by: momoe, Dec 27, 2019 in forum: Troubleshooting
  9. momoe
    Post

    Solved Heat sink mounting issues

    It’s an original R1 that I updated the screw arms when I broke the hotbed. This thing is old. When I talked with Robo, they said it was the R1+...
    Post by: momoe, Dec 27, 2019 in forum: Troubleshooting
  10. momoe
    Thread

    Solved Heat sink mounting issues

    Hi all. Need help. I dusted off the old printer (robo 3D R1)and am reassembling it after some time. I had to replace the whole hot end from the...
    Thread by: momoe, Dec 26, 2019, 16 replies, in forum: Troubleshooting
  11. momoe
    Post

    Screw size needes

    Thanks. That’s the ones I mean
    Post by: momoe, Nov 18, 2018 in forum: General Questions
  12. momoe
    Thread

    Screw size needes

    Can someone tell me what size and thread the screws are that hold the heat sink in the carriage? I know it’s metric but not sure the thread or...
    Thread by: momoe, Nov 18, 2018, 4 replies, in forum: General Questions