1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by NerdMomma

  1. NerdMomma
    Post

    R2 wants to start print beyond starting perimeters

    So it's possible that my axis were out of whack? I adjusted them this afternoon, after print #2. I don't know. It printed fine this morning and...
    Post by: NerdMomma, Jun 19, 2017 in forum: Troubleshooting
  2. NerdMomma
    Post

    R2 wants to start print beyond starting perimeters

    I shut it down last night and left it. On a whim this morning, I tried it one more time. I kid you not, it started printing normally WITH THE SAME...
    Post by: NerdMomma, Jun 19, 2017 in forum: Troubleshooting
  3. NerdMomma
    Post

    R2 wants to start print beyond starting perimeters

    I will check tomorrow afternoon. I am so frustrated that I had to walk away for the evening. 2+ weeks and it has been one thing, then another.
    Post by: NerdMomma, Jun 18, 2017 in forum: Troubleshooting
  4. NerdMomma
    Post

    R2 wants to start print beyond starting perimeters

    Yes, it homes just fine. If you notice the different sources of Gcode, this isn't from one specific file or program. It does this with the...
    Post by: NerdMomma, Jun 18, 2017 in forum: Troubleshooting
  5. NerdMomma
    Thread

    R2 wants to start print beyond starting perimeters

    Ugh. I hate that I'm starting to regret backing the R2. My R1+ has been great since day 1.... Now I can't even print. It keeps wanting to start...
    Thread by: NerdMomma, Jun 18, 2017, 14 replies, in forum: Troubleshooting