Recent Content by OscarGrouch

Thread

I have a Bambu Lab A1 which comes with the standard .4mm nozzle. It prints great except when the print layer is less than .2 If I go less than...

Thread by: OscarGrouch, Apr 12, 2026, 1 replies, in forum: General Questions

Post

Thanks.

Post by: OscarGrouch, Mar 8, 2026 in forum: Troubleshooting

Thread

I was printing a large dragon. It was a 9.5 hour job. I’d check on it every hour or so. The last time I checked, over half was done. The head...

Thread by: OscarGrouch, Mar 7, 2026, 2 replies, in forum: Troubleshooting

Post

Mark, Thanks for your quick reply. The slicer app lost connection with the printer and I couldn’t fix it through the Bambu Studio slicer app....

Post by: OscarGrouch, Feb 21, 2026 in forum: Troubleshooting

Post

Post by: OscarGrouch, Feb 21, 2026 in forum: Troubleshooting

Thread

Using Bambu Studio. All worked well until the slicer software quit recognizing the A1 printer. I’ve deleted and reinstalled the software 3 times...

Thread by: OscarGrouch, Feb 21, 2026, 5 replies, in forum: Troubleshooting