1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by robert baldwin

  1. robert baldwin
    Profile Post

    Working on restoring a Robo R1

    Working on restoring a Robo R1
    Status update by robert baldwin, Oct 18, 2021
  2. robert baldwin
    Thread

    Restored an R1 to operation :)

    I picked up and Robo 3D R1 off craigslist. $100. The extruder connector was not attached. The small fan wire were broken off, and is was so dirty...
    Thread by: robert baldwin, Oct 17, 2021, 0 replies, in forum: Show and Tell
  3. robert baldwin
    Post

    Solved Stepper motors seem to keep running after home

    It didn’t do so go. Looks like x-axis not tracking straight .
    Post by: robert baldwin, Oct 17, 2021 in forum: Troubleshooting
  4. robert baldwin
    Post

    Solved Stepper motors seem to keep running after home

    Yes, that they are, they were just making noise after. I adjusted the drive current on all drivers and that took care of it. Set all to 0.6V ....
    Post by: robert baldwin, Oct 17, 2021 in forum: Troubleshooting
  5. robert baldwin
    Thread

    Solved Stepper motors seem to keep running after home

    Hello; I'm refurbishing a Robo 3d r1. I notice if I do a Home example X axis It goes to home but then after a few seconds it start to squeal, you...
    Thread by: robert baldwin, Oct 13, 2021, 3 replies, in forum: Troubleshooting