1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Roger Worden

  1. Roger Worden
    Post

    Unresolved Home command fail before Auto Level?

    OK, I'll try that some time this weekend. I have not updated the R1+ firmware before. Is there a preferred stable version?
    Post by: Roger Worden, Dec 31, 2020 in forum: Troubleshooting
  2. Roger Worden
    Post

    Unresolved Home command fail before Auto Level?

    G28 (plain) moves the head to the left, then the bed to the back. Then it moves both to near center, moves Z down to touch the bed. M114 then...
    Post by: Roger Worden, Dec 31, 2020 in forum: Troubleshooting
  3. Roger Worden
    Thread

    Unresolved Home command fail before Auto Level?

    I am experiencing an intermittent failure of auto leveling at the start of a print job. I will post this on both the Simplify3D site and the...
    Thread by: Roger Worden, Dec 31, 2020, 6 replies, in forum: Troubleshooting
  4. Roger Worden
    Thread

    Unanswered Auto Leveling not starting near (0,0)

    Robo3D R1+, firmware Marlin V1. Simplify3d 4.1.2 (not sure it matters) This is an intermittent problem, not constant. When starting a print, the...
    Thread by: Roger Worden, Mar 28, 2020, 0 replies, in forum: Troubleshooting
  5. Roger Worden
    Thread

    Unanswered Minimum nozzle size for R1+ ?

    Is there a minimum nozzle size for the R1+ ? I got a near-instant jam with PLA at 0.2 and am wondering if there are any specified or practical limits.
    Thread by: Roger Worden, May 18, 2019, 1 replies, in forum: Troubleshooting