1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Section 31HQ

  1. Section 31HQ
    Post

    How to get STL Thumbnail View using Windows Explorer

    Many Thanks!!:):D
    Post by: Section 31HQ, Sep 23, 2016 in forum: Software
  2. Section 31HQ
    Post

    Multi extruder upgrade?

    Success! Thank you guys for all the answers. Mark, you were right about the changes being what you remembered. What I did was correct, as others...
    Post by: Section 31HQ, Sep 16, 2016 in forum: Mods and Upgrades
  3. Section 31HQ
    Post

    Multi extruder upgrade?

    Thanks Mark. Will do. Just for kicks I reinstalled the official firmware and extruder motor 1 moves fine, so you are right that some more changes...
    Post by: Section 31HQ, Sep 15, 2016 in forum: Mods and Upgrades
  4. Section 31HQ
    Post

    Multi extruder upgrade?

    Thanks Mark. First, I followed this guide posted above...
    Post by: Section 31HQ, Sep 15, 2016 in forum: Mods and Upgrades
  5. Section 31HQ
    Post

    Multi extruder upgrade?

    Sorry to re-open this thread, but I've had "partial" luck with the mod. I had to put it in the back burner for a long while due to stuff...
    Post by: Section 31HQ, Sep 15, 2016 in forum: Mods and Upgrades
  6. Section 31HQ
    Post

    Multi extruder upgrade?

    Thanks for the answers guys. I'll be busy this weekend:)
    Post by: Section 31HQ, Jul 18, 2016 in forum: Mods and Upgrades
  7. Section 31HQ
    Thread

    Multi extruder upgrade?

    Hello, I read that the R1+ does not have a "standard" RAMPS shield. Is there a reason for the Z motors being handled by separate drivers? Can they...
    Thread by: Section 31HQ, Jul 18, 2016, 15 replies, in forum: Mods and Upgrades
  8. Section 31HQ
    Post

    Making Filament

    One of many reasons why I got my Robo was to print the big parts for this http://www.thingiverse.com/thing:380987 Recycling the fails and pellets...
    Post by: Section 31HQ, Feb 9, 2016 in forum: Off Topic
  9. Section 31HQ
    Post

    Solved Firmware changes?

    Thanks Mark! I'll check it out.
    Post by: Section 31HQ, Feb 9, 2016 in forum: Troubleshooting
  10. Section 31HQ
    Thread

    Solved Firmware changes?

    Hello, I'm new to the forum and I bought a R1+ last week. I read the information about the compiled firmware being available by request, but I'd...
    Thread by: Section 31HQ, Feb 9, 2016, 3 replies, in forum: Troubleshooting
  11. Section 31HQ
    Post

    Solved .

    First post, bumping this. I have the same issue. I only print in ABS.
    Post by: Section 31HQ, Feb 9, 2016 in forum: Troubleshooting