1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by simonw

  1. simonw
    Post

    Solved Err Message

    If your fan is blowing on your extruder you may need to lower your fan speed. Had this after adding second fan. This would happen after second...
    Post by: simonw, May 26, 2017 in forum: Troubleshooting
  2. simonw
    Post

    Solved printer not printing round object

    will try when i get home this evening. thanks
    Post by: simonw, Feb 11, 2016 in forum: Troubleshooting
  3. simonw
    Post

    Solved printer not printing round object

    When i slow it down drastically it prints okay. but that behavior changed. i didn't need to slow it down prior. i did tighten both belts with not...
    Post by: simonw, Feb 11, 2016 in forum: Troubleshooting
  4. simonw
    Post

    Solved printer not printing round object

    thanks again. I"m new to this. can you send me a link or photo showing me what needs to be tightened. (where the adjustment screws are located)...
    Post by: simonw, Feb 8, 2016 in forum: Troubleshooting
  5. simonw
    Post

    Solved printer not printing round object

    thanks for your reply. this is the same material and settings i have used many times successfully(as recent as two days ago). this is a problem...
    Post by: simonw, Feb 8, 2016 in forum: Troubleshooting
  6. simonw
    Thread

    Solved printer not printing round object

    Hi all, this is a new problem,. it was working fine till two days ago. i can print rectangular shapes with no issue. i suddenly can't print this...
    Thread by: simonw, Feb 8, 2016, 9 replies, in forum: Troubleshooting