1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Sir_Kibble

  1. Sir_Kibble
    Post

    Partially Solved Connected to Arduino, but printer not responding to commands

    I'll grab another kit and return the other board. It may be a while before I can post back with the results, as I'll be leaving town for a couple...
    Post by: Sir_Kibble, Jul 19, 2017 in forum: Troubleshooting
  2. Sir_Kibble
    Post

    Partially Solved Connected to Arduino, but printer not responding to commands

    What works: All temperature sensors, Arduino, Heating bed(sort of? Still doesn't turn off), power supply What doesn't: All steppers, All...
    Post by: Sir_Kibble, Jul 13, 2017 in forum: Troubleshooting
  3. Sir_Kibble
    Post

    Partially Solved Connected to Arduino, but printer not responding to commands

    Got the new board, hooked it up, same result. The new board is advertised as tested so it's got to be something else.
    Post by: Sir_Kibble, Jul 12, 2017 in forum: Troubleshooting
  4. Sir_Kibble
    Post

    Partially Solved Connected to Arduino, but printer not responding to commands

    That's what I was afraid of... I'll order a new one and give it a whirl. Should I close this topic out or wait until I get the new board in?...
    Post by: Sir_Kibble, Jun 12, 2017 in forum: Troubleshooting
  5. Sir_Kibble
    Post

    Partially Solved Connected to Arduino, but printer not responding to commands

    My pictures are too large for the forum, so I'm linking them on imgur. http://imgur.com/a/LSLbm
    Post by: Sir_Kibble, Jun 8, 2017 in forum: Troubleshooting
  6. Sir_Kibble
    Post

    Partially Solved Connected to Arduino, but printer not responding to commands

    Okie dokes, so I flashed the stock firmware successfully, but the problem persists. What do you recommend next?
    Post by: Sir_Kibble, Jun 7, 2017 in forum: Troubleshooting
  7. Sir_Kibble
    Post

    Partially Solved Connected to Arduino, but printer not responding to commands

    I'll reflash the stock firmware tomorrow and post back with results. Thanks!
    Post by: Sir_Kibble, Jun 6, 2017 in forum: Troubleshooting
  8. Sir_Kibble
    Post

    Partially Solved Connected to Arduino, but printer not responding to commands

    Yes, I changed the shield to RAMPS 1.4 to go dual extrusion. I uploaded the Robo3d R1+ firmware and modified the configuration.h motherboard...
    Post by: Sir_Kibble, Jun 4, 2017 in forum: Troubleshooting
  9. Sir_Kibble
    Thread

    Partially Solved Connected to Arduino, but printer not responding to commands

    Howdy everyone! I recently changed the arduino shield on my R1+ and edited the firmware accordingly, but now none of the motors respond to...
    Thread by: Sir_Kibble, Jun 3, 2017, 23 replies, in forum: Troubleshooting
  10. Sir_Kibble
    Thread

    Robo R1+ not responsive after chimera upgrade

    Howdy! I've been following the Chimera Upgrade Guide (WIP)(can't link due to spam filter) but sorta had to wing it towards the end. Everything...
    Thread by: Sir_Kibble, May 28, 2017, 1 replies, in forum: Mods and Upgrades