1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Tanbam

  1. Tanbam
    Post

    Solved Problem with Z Offset on LCD Display

    I got busy and didn’t work on it again until today, and I decided to just start from scratch. I adjusted the Merlin 2.0 firmware posted in here...
    Post by: Tanbam, Aug 14, 2021 in forum: Troubleshooting
  2. Tanbam
    Post

    Solved Problem with Z Offset on LCD Display

    I was originally using stock firmware. I agree that the z offset in the GCode should have worked, but it didn’t. I’m using the exact command...
    Post by: Tanbam, Aug 9, 2021 in forum: Troubleshooting
  3. Tanbam
    Post

    Solved Problem with Z Offset on LCD Display

    Thanks for the link, but that wasn’t my issue. I’m fairly familiar with getting these things tuned. The only problem that I was having was that...
    Post by: Tanbam, Aug 9, 2021 in forum: Troubleshooting
  4. Tanbam
    Thread

    Solved Problem with Z Offset on LCD Display

    It’s been a while since I’ve posted here. Back around 2015, I brought my R1 to the office so everyone could use it, and after a couple of months...
    Thread by: Tanbam, Aug 8, 2021, 8 replies, in forum: Troubleshooting
  5. Tanbam
    Post

    Unresolved Power mystery

    The fan connector on the bottom fan isn't keyed, so it's possible to plug it in backwards. It'll still spin just fine, but the air will be...
    Post by: Tanbam, Mar 24, 2016 in forum: Troubleshooting