1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by tkoco

  1. tkoco
    Post

    My reborn C2

    You may want to read the C2 FAQ for good information gathered over the years.
    Post by: tkoco, Feb 27, 2023 in forum: Show and Tell
  2. tkoco
    Post

    Raspberry Pi 4?

    I believe that the issue is that the original Robo OS was based on an older 32 bit Raspberry OS which is not compatible with the CPU on the PI 4....
    Post by: tkoco, Dec 1, 2022 in forum: Software
  3. tkoco
    Post

    Starts out fine then goes crumbly

    Lance, thank you for the insight on that problem.
    Post by: tkoco, Dec 1, 2022 in forum: Troubleshooting
  4. tkoco
    Post

    Starts out fine then goes crumbly

    Nice Print
    Post by: tkoco, Dec 1, 2022 in forum: Troubleshooting
  5. tkoco
    Post

    Replace that old style Bowden tube

    The friction co-efficient is lower for Capricorn tubing vs the factory issued tubing. Add to that, the fact that the Capricorn tubing is a direct...
    Post by: tkoco, Nov 10, 2022 in forum: Mods and Upgrades
  6. tkoco
    Post

    Filament FAQ

    Having difficulty with a known good filament brand? Slicer software will assign a generic density value to filaments when you add the filament to...
    Post by: tkoco, Nov 4, 2022 in forum: Filament
  7. tkoco
    Post

    32-Bit Heart Transplant for the Robo R2

    I had a look at the klipper project. Interestingly enough, the GitHub site has a config file for the stock R2 printer. Those of you reading this...
    Post by: tkoco, Oct 24, 2022 in forum: Projects
  8. tkoco
    Post

    What’s this part called?

    Probably need to re-post the item as a "For Sale" message
    Post by: tkoco, Oct 19, 2022 in forum: General Questions
  9. tkoco
    Post

    The Master thread concerning Cura

    Another "gotcha" for Cura 5.x: When you create / load a new filament, Cura will not update custom quality profiles with the settings of the...
    Post by: tkoco, Oct 18, 2022 in forum: Software
  10. tkoco
    Post

    What’s this part called?

    I had to replace that back in 2015. I forget the official designation, but I seem to remember something like: platform support assembly. Do you...
    Post by: tkoco, Oct 18, 2022 in forum: General Questions
  11. tkoco
    Post

    Cura 5

    The amount of time saved will depend on the model. A model with lots of curved surfaces (like an organic vase) will benefit from arc welder. A...
    Post by: tkoco, Oct 17, 2022 in forum: Software
  12. tkoco
    Thread

    Bowden tube replacement

    Read this thread in the R2 Mods area: http://community.robo3d.com/index.php?threads/replace-that-old-style-bowden-tube.24850/ It is applicable to...
    Thread by: tkoco, Oct 16, 2022, 0 replies, in forum: Mods and Upgrades
  13. tkoco
    Thread

    Replace that old style Bowden tube

    https://www.amazon.com/dp/B079P92HN9 The tube going from the filament sensor to the extruder... the original tubing specification is mediocre....
    Thread by: tkoco, Oct 16, 2022, 4 replies, in forum: Mods and Upgrades