1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by WillisBench

  1. WillisBench
    Post

    Extruder Picking Up Print

    I'm downloading the newest version from the website right now. I think this might be a good solution. Typically, I'll pull a schematic from...
    Post by: WillisBench, Jun 1, 2020 in forum: Troubleshooting
  2. WillisBench
    Post

    Extruder Picking Up Print

    I'm using Cura for Robo 2.5.0. My most recent print came out somewhat clean, with minimal warping. Maybe I was just using bad schematics.
    Post by: WillisBench, May 28, 2020 in forum: Troubleshooting
  3. WillisBench
    Post

    Extruder Picking Up Print

    This seems like a great jumping off point. Thanks so much for your help.
    Post by: WillisBench, May 27, 2020 in forum: Troubleshooting
  4. WillisBench
    Post

    Extruder Picking Up Print

    Thanks for a prompt response, Mark. I've run through the calibration wizards (Z Offset, Bed Calibration, and Fine Tune Z Offset in that order) and...
    Post by: WillisBench, May 27, 2020 in forum: Troubleshooting
  5. WillisBench
    Thread

    Extruder Picking Up Print

    I've been trying to print some figurines lately and the extruder keeps picking the project up off of the print bed and leaving these globules of...
    Thread by: WillisBench, May 27, 2020, 8 replies, in forum: Troubleshooting