1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Polymaker Pc PC-Plus Natural Transparent

Discussion in 'Printing Filament' started by spankurmonkey, Jan 18, 2017.

  1. spankurmonkey

    spankurmonkey Member

    Joined:
    Dec 26, 2016
    Messages:
    102
    Likes Received:
    3
    New question for the day.... made yet another ordering error... thought I was ordering good old PLA but clear but that does not seem the case... https://www.amazon.com/gp/product/B01BMWTG8G/ Anyone know anything about this and can the Stock Robo 3d print this stuff?
     
    #1 spankurmonkey, Jan 18, 2017
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    a stock robo will not print that material. To hot (In my opinion).

    Edit: meaning I think the max temp for the robo is probably lower than what you will run that material at.
     
    #2 Geof, Jan 18, 2017
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    If you can print it at 250 it might work ... not sure.
    You will need to look in the CONFIGURATION.H for the firmware version you are using.
    There will (or should ) be a line like this:

    #define HEATER_0_MAXTEMP 290 //robo

    but I do not remember if that is the actual value (290) that Robo uses. I might have modified mine
     
    #3 mark tomlinson, Jan 18, 2017
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Stock Robo R1+PLUS firmware is set to 290°C max.
     
    #4 WheresWaldo, Jan 18, 2017
    Camilo Vasquez, mark tomlinson and Geof like this.

Share This Page