1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Look what i just got

Discussion in 'Troubleshooting' started by Nathanfish, Feb 3, 2017.

Thread Status:
Not open for further replies.
  1. Nathanfish

    Nathanfish Active Member

    Joined:
    Aug 6, 2015
    Messages:
    306
    Likes Received:
    34
    10Kg of PETG! Now the troubleshooting, any ideas on how i should hold this thing other than bar stools and a broom? hahaha. I was a little worried it would strip out the filament because of all the weight to turn but it's working so far.
     

    Attached Files:

  2. Nathanfish

    Nathanfish Active Member

    Joined:
    Aug 6, 2015
    Messages:
    306
    Likes Received:
    34
    Nice, good idea. Wasn't thinking of building one to hold spools for both my printers. Back to the drawing board.
     
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    That one has the advantage of being movable :)
    I was going to do the wall mount, but the printers have moved several times since then.
     
Thread Status:
Not open for further replies.

Share This Page