1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Waves in print

Discussion in 'Troubleshooting' started by Wgreisi, Mar 22, 2017.

  1. Wgreisi

    Wgreisi New Member

    Joined:
    Mar 20, 2017
    Messages:
    27
    Likes Received:
    2
    Has anyone ever had waves after features on the print. You can see them in the picture. They exist around every hole and are all all in the same direction as you are looking at the part.

    upload_2017-3-22_14-26-5.png

    The top edge of the part was the bottom edge of the print (print bed). It was printed using mattercontol and the default high quality setting for PLA. I am having this same issue on multiple prints.

    Thanks
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
  3. Wgreisi

    Wgreisi New Member

    Joined:
    Mar 20, 2017
    Messages:
    27
    Likes Received:
    2
    do you have a speed recommendation, specifically for the high quality prints? This is a 100% stock 3D R1+
     
  4. dbvanhorn

    dbvanhorn Active Member

    Joined:
    Feb 15, 2015
    Messages:
    166
    Likes Received:
    36
    I agree on both counts. I'd give you my settings, (I slowed down) but it's printing and I can't get to them for some hours yet.

    I slowed down the max speed, acceleration, and "Jerk" from the factory settings. It's not so fast now, but it prints nicely and the machine doesn't shake the table when it's running.
     
  5. Wgreisi

    Wgreisi New Member

    Joined:
    Mar 20, 2017
    Messages:
    27
    Likes Received:
    2
    That would be great
     

Share This Page