Solved New R1+ Not Autoleveling correctly

New R1+, right out of box. When it goes to do the 9 pt autoleveling it starts in the middle (not X0 Y0 Z0) and then goes to the right. Next it stays along the far right, even trying to go further right. It's like the whole bed is mapped far right off the bed. I checked wiring and looks same as my old r1+. Any help is much appreciated.

Sent from my VS990 using Tapatalk

 

I figured it out: the person who assembled it switched the wiring around on the sensors on the left side. Not too happy with Robo on some shoddy manufacturing.