1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Titan Aero on a CNC Mill

Discussion in 'Off Topic' started by KTMDirtFace, May 27, 2017.

  1. KTMDirtFace

    KTMDirtFace Well-Known Member

    Joined:
    May 18, 2015
    Messages:
    1,247
    Likes Received:
    461
    This is pretty cool. Probably super accurate :)

     
    #1 KTMDirtFace, May 27, 2017
    Last edited: May 27, 2017
  2. daniel871

    daniel871 Well-Known Member

    Joined:
    Apr 18, 2015
    Messages:
    1,322
    Likes Received:
    510
    People have been doing that on CNC Sharks sold by Rockler for a few years now. Just not with the Titan Aero (it's one of the MK-variants I believe).

    Only bad thing is the Z-axis is super limited on hobby-level mills.
     
    #2 daniel871, May 29, 2017
  3. KTMDirtFace

    KTMDirtFace Well-Known Member

    Joined:
    May 18, 2015
    Messages:
    1,247
    Likes Received:
    461
    Oh i hadn't seen it before.

    I can see the z axis being a problem. just thought it was neat.
     
    #3 KTMDirtFace, May 29, 2017
  4. daniel871

    daniel871 Well-Known Member

    Joined:
    Apr 18, 2015
    Messages:
    1,322
    Likes Received:
    510
    https://www.pinterest.com/pin/231302130839870301/

    That particular one isn't MK-based. Not sure what they based it on now that I'm looking at it again.
     
    #4 daniel871, May 30, 2017

Share This Page