1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Filiment issue

Discussion in 'Troubleshooting' started by BenThehybrid, Jun 6, 2017.

  1. BenThehybrid

    BenThehybrid New Member

    Joined:
    Jun 6, 2017
    Messages:
    2
    Likes Received:
    0
    Ok so when i click start print the filliment doesn't move so i have to keep pushing it then it comes out. How do i make it do it by its self?
     
  2. Dylan Zilifian

    Dylan Zilifian New Member

    Joined:
    Jun 6, 2017
    Messages:
    9
    Likes Received:
    2
    Try to manually extrude filament on MatterControl. Do this by going to setting and controls, then clicking on controls. There is an option to extrude by pressing the E+ button. If you see the plastic gears moving on the extruder than you man need to look at the hobbed bolt (rigid thing that's by the hole you feed your filament). It may to be cleaned. If they aren't moving than you may need to replace your extruder or contact Robo support.
     
  3. Dylan Zilifian

    Dylan Zilifian New Member

    Joined:
    Jun 6, 2017
    Messages:
    9
    Likes Received:
    2
    Also if the gears are turning, than you can also put a little cooking oil on the beginning of your filament to help it start feeding.
     
  4. m4r1n5

    m4r1n5 Member

    Joined:
    Mar 31, 2016
    Messages:
    98
    Likes Received:
    26
    Or tighten the adjustment screws

    Sent from my LG-H830 using Tapatalk
     

Share This Page