1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Borosilicate Glass Bed Mod (sort of for now)

Discussion in 'Mods and Upgrades' started by jwmueller, Jun 11, 2017.

Page 2 of 2
  1. jwmueller

    jwmueller Active Member

    Joined:
    Jun 5, 2017
    Messages:
    169
    Likes Received:
    51
    Running a full size perimeter test per full specs now, well in 6-mins when the bed is clear.
     
    #21 jwmueller, Jun 12, 2017
    Geof likes this.
  2. jwmueller

    jwmueller Active Member

    Joined:
    Jun 5, 2017
    Messages:
    169
    Likes Received:
    51
    I did not get a full 203mm square, I got close to the 197mm. Since my rods are bent my test did not fully stick. Getting that first layer down on a long run when your extruder is on a tilt-a-whirl is not easy... LOL

    Two things, limit switches and the gantry hitting the other side.
     
    #22 jwmueller, Jun 12, 2017
    Alan Laing likes this.
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Hey @jwmueller send me a PM I don't use 3DHubs and I am a bit curious about what kind of business you can derive from that avenue, Send me a PM so we can chat.
     
    #23 WheresWaldo, Jun 13, 2017
    Geof likes this.
  4. Pilsnerboy

    Pilsnerboy New Member

    Joined:
    Jun 9, 2017
    Messages:
    19
    Likes Received:
    2
    #24 Pilsnerboy, Jun 13, 2017
Page 2 of 2

Share This Page