1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Control Z-Height on LCD XXL Screen During Print

Discussion in 'Mods and Upgrades' started by NLCarrII, Jun 21, 2017.

  1. NLCarrII

    NLCarrII New Member

    Joined:
    Aug 8, 2014
    Messages:
    2
    Likes Received:
    0
    Hello Forum,

    I am getting back to using my Robo. I've had it for a few years, and always had issues with the Z-Height calibration and the switches. Well I finally figured out that one was never sending a signal. Well foast forward to now, I got the XXL Screen from Printed Solid, but I don't see anywhere to adjust the Z-Height during a print. Do I just change the Z-Offset? It doesn't look like it changes much.

    I feel like what you're going to tell me is to fine tune my Z-Height, but I do like micro adjusting the Z-Height from Matter Control and now I can't figure how to do that from the screen.

    Best Regards,

    Nate
     
  2. Ryan TeGantvoort

    Ryan TeGantvoort Active Member

    Joined:
    Mar 11, 2016
    Messages:
    343
    Likes Received:
    172
    Look up Babystep, I believe that is what you are looking for
     
    NLCarrII likes this.
  3. NLCarrII

    NLCarrII New Member

    Joined:
    Aug 8, 2014
    Messages:
    2
    Likes Received:
    0
    Thank you Sir! Will implement this weekend.
     

Share This Page