1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

My print has whiskers

Discussion in 'Troubleshooting' started by aaronwstone, Aug 20, 2017.

  1. aaronwstone

    aaronwstone New Member

    Joined:
    May 28, 2017
    Messages:
    29
    Likes Received:
    4
    Just wondering what you guy thought would cause the print to end up like this. In some spots it was just spitting the filament out on the bed..
     

    Attached Files:

    #1 aaronwstone, Aug 20, 2017
  2. Kilrah

    Kilrah Well-Known Member

    Joined:
    Apr 18, 2017
    Messages:
    498
    Likes Received:
    332
    What's the model supposed to be like, are these holes intended? Looks like supports are needed for that bit. Can't print on top of nothing.

    Looks like you've got a few layers where filament didn't feed correctly too.
     
    #2 Kilrah, Aug 20, 2017
    mark tomlinson likes this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Yea, not a replicator... not yet.
     
    #3 mark tomlinson, Aug 20, 2017
  4. aaronwstone

    aaronwstone New Member

    Joined:
    May 28, 2017
    Messages:
    29
    Likes Received:
    4
    makes since ... THANKS!!
     
    #4 aaronwstone, Aug 21, 2017

Share This Page