1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Noise

Discussion in 'Troubleshooting' started by Jaak Ahelik, Sep 9, 2017.

  1. Jaak Ahelik

    Jaak Ahelik New Member

    Joined:
    Aug 22, 2017
    Messages:
    20
    Likes Received:
    8
    Before the extruder starts to move, it makes terrible noise (in left corner)?



    Metal backplate is connected to the plastic, how to change the position?
     

    Attached Files:

    #1 Jaak Ahelik, Sep 9, 2017
    Last edited: Sep 9, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Home switch(es) are not being made. You need to eyeball them and see if they got knocked over too close to the wall.
     
    #2 mark tomlinson, Sep 9, 2017
    Geof likes this.
  3. Jaak Ahelik

    Jaak Ahelik New Member

    Joined:
    Aug 22, 2017
    Messages:
    20
    Likes Received:
    8
    To save time, can you give me advice how to set it.
    Thx
     
    #3 Jaak Ahelik, Sep 9, 2017
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #4 mark tomlinson, Sep 9, 2017
    Geof and Jaak Ahelik like this.

Share This Page