1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Slicing problem MAtterControl and Cura

Discussion in 'Software' started by Crypto3d, Nov 3, 2017.

  1. Crypto3d

    Crypto3d New Member

    Joined:
    Oct 10, 2017
    Messages:
    15
    Likes Received:
    6
    In the attached picture the chain link on the left was sliced and printed with matter control/matter slice. The one on the right was printed and sliced with cura (latest version). Obviously the one from cura is lower quality. Any idea what settings I might be able to tweak to clean it up? When I setup cura I tried to match up everything with what I had in matter control as much as possible.
     

    Attached Files:

  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    moved to software section
     
  3. book

    book New Member

    Joined:
    Nov 24, 2017
    Messages:
    2
    Likes Received:
    0
    Not sure if this is your problem, but when I first started using Cura 3.0, I saw that Cura wasn't using the default firmware acceleration and jerk setttings. Cura acceleration and jerk were set to 3000m/s2 and 25m/s3.
    I changed it to 1300m/s2 and 17m/s3 and my print qualities improved.
     

Share This Page