1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Z Axis Switch on right is always being pressed.

Discussion in 'Troubleshooting' started by Hanover, Nov 24, 2017.

Thread Status:
Not open for further replies.
  1. Hanover

    Hanover Member

    Joined:
    Jul 22, 2017
    Messages:
    99
    Likes Received:
    28
    Today I noticed that the printer was no longer leveling correctly. Somehow the switch on the left is always being pressed down by the weight of the extruder whenever the extruder moves to the left. I've tried adjusting it, but I'm not really sure what to adjust. Does anyone know how to fix this?

    It's an Robo R1+.
     
    #1 Hanover, Nov 24, 2017
  2. Hanover

    Hanover Member

    Joined:
    Jul 22, 2017
    Messages:
    99
    Likes Received:
    28
    Disreagard this. One of the wires going to the switch was accidentally pulled out and we put it back on the "Closed is On" connector.
     
    #2 Hanover, Nov 24, 2017
    mark tomlinson likes this.
Thread Status:
Not open for further replies.

Share This Page