1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Help with e3d v6

Discussion in 'Troubleshooting' started by grant, Dec 30, 2017.

  1. grant

    grant New Member

    Joined:
    Aug 7, 2017
    Messages:
    24
    Likes Received:
    3
    Does anyone know if the old pins for the extruder fan is 12volts? This is the new ramps board. I did not text before I took everything apart. Here is the new board with the pins circled in red.
     

    Attached Files:

  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    The RAMPS board will accept 12-24V if your Power Supply is 12V you need a 12V E3Dv6
     
  3. grant

    grant New Member

    Joined:
    Aug 7, 2017
    Messages:
    24
    Likes Received:
    3
    No I understand that, I'm trying to wire in the heatsink fan, and I need 12 volts. I was seeing if anyone knew if the old extruder fan was wired at 12volts on the board. This way I could just splice the new wires in.
     
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Yes, you can even just wire it straight back to the power supply. There is no reason for it not to be on with the power switch
     
  5. grant

    grant New Member

    Joined:
    Aug 7, 2017
    Messages:
    24
    Likes Received:
    3
    Alright thanks!
     

Share This Page