Does anyone here have a working Cura 3.0.4 for R1 Plus ?

Hi,
Does anyone here have a working Cura 3.0.1 printer profile for the R1 +

 

I was impressed with the results that I got with MatterControl and since the company that sells the stl files for the r/c airplane I'm making includes Simplify3D optimizations I bought Simplify3D. I printed the same test object to compare... the spinning top.
The print is great!

 

I have been using 3.0.4 successfully, what is your question, maybe I can help?

I can tell you this much, I did have one change I made because it was printing mid air.
goto settings, printer, manage printer.
from the left column select "printer" and over on the right select "machine settings"
I put this in the "Start Gcode" box and it works great now.

G21 ;metric values
G90 ;absolute positioning
M82 ;set extruder to absolute mode
G28 ;move X/Y/Z to min endstops
M565 Z-.97 ;set Z-Offset in mm (may need adjusting for your specific printer)
G29 ;run auto-level routine
G92 E0 ;zero the extruded length
G190 S{print_bed_temperature) ;set bed temperature and wait
G109 S{print_temperature} ;set extruder temperature and wait
M 117 Printing...

 

I am having the same problem. But with S3D works fine. I really need Cura to work on my Robo because the detailed profile I don’t get in simplify. Also, my prints were starting in the front left corner. I will try you tip on the gcode. I hope this time it will print fine and not air.

 

Great Info, Can you help with your End Gcode?

 

Thank you.

This is the end Gcode.

G92 Z0 ;set current z position to be new 0

G91 ;relative positioning

G1 E-1 F300 ;retract the filament a bit before lifting the nozzle to release some of the pressure

G1 Z+0.5 E-5 F9000 ;move Z up a bit and retract filament even more

G90 ;absolute positioning

M104 S0 ;turn off extruder heat

M140 S0 ;turn off heated bed

G1 X10 Y230 ;extend bed out front

M84 ;disable motors

 

I have problem too.

 

Thanks you very much. Great info