1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Hotend connectors?

Discussion in 'General Questions' started by Park A., Dec 21, 2017.

  1. Park A.

    Park A. New Member

    Joined:
    Nov 2, 2017
    Messages:
    27
    Likes Received:
    15
    Hey guys, anyone know the nomenclature for the r2 stock hotend connectors? Micro JST? Molex, maybe? It's two separate two-pin connectors, but I'm not sure about the pin spacing or type of connector to ask for whilst shopping.

    I'm installing an all-metal hotend, and would like to crimp end-pins/connectors, vice cutting and splicing wires.

    I apologize in advance if this has already been covered, admittedly I did not do a thorough search as I probably should have.
     
    #1 Park A., Dec 21, 2017
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    #2 WheresWaldo, Dec 21, 2017
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    I opened a ticket with Robo Support via email to see if I can get this answer substantiated.
     
    #3 WheresWaldo, Dec 21, 2017
    Geof and Park A. like this.
  4. AllenMcAfee

    AllenMcAfee Guest

    The connectors on the hotend itself are as follows:

    Heater cartridge: JST EH connector B2B-EH-A(LF)(SN)
    Thermistor: JST PH connector B2B-PH-K-S(LF)(SN)
     
    #4 AllenMcAfee, Jan 20, 2018
    Geof, supercazzola, mark tomlinson and 1 other person like this.
  5. supercazzola

    supercazzola Active Member

    Joined:
    Jun 1, 2017
    Messages:
    424
    Likes Received:
    111
    #5 supercazzola, Feb 4, 2018

Share This Page