1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Robo R2 Filament Cleaner

Discussion in 'Mods and Upgrades' started by Shrey, Jan 20, 2018.

Page 3 of 3
  1. supercazzola

    supercazzola Active Member

    Joined:
    Jun 1, 2017
    Messages:
    424
    Likes Received:
    111
    No need to. You have a valid point. I sure like how the 2nd clip works. I do get more noise from filament as it enters the bottom hole but that is okay. I don’t think it is causing too much resistance.


    Sent from my iPhone using Tapatalk Pro
     
    #41 supercazzola, Feb 7, 2018
  2. Shrey

    Shrey Active Member

    Joined:
    Jul 6, 2017
    Messages:
    143
    Likes Received:
    60
    I’ve been using the second clip as well I haven’t had any issues in print quality I’ve printed very small to large and no issue so far


    Sent from my iPhone using Tapatalk
     
    #42 Shrey, Feb 7, 2018
  3. DavidR

    DavidR Member

    Joined:
    Jan 3, 2018
    Messages:
    78
    Likes Received:
    13
    Nice. I can also recommend eSun's cleaning filament. Seems to work well. Has a temperature interval that extends over virtually all filaments and has an adhesive quality as well. I also will spray filaments down with dust-off before loading them though I can't say for sure that it necessarily does anything.
     
    #43 DavidR, Feb 10, 2018
    supercazzola likes this.
Page 3 of 3

Share This Page