1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Replacing hexagon hot end nozzle with mk8 nozzle

Discussion in 'Troubleshooting' started by cnr141, May 19, 2015.

Thread Status:
Not open for further replies.
  1. cnr141

    cnr141 Member

    Joined:
    Aug 6, 2014
    Messages:
    46
    Likes Received:
    0
    Replacing hexagon hot end nozzle with mk8 nozzle is OK but there is such a problem that even i have retraction ,the filament goes out from the nozzle and makes hairy places between the male models. Is there any solution or settings about the firmware..

    the example on the pic is a good one normally it is much more worse.
     

    Attached Files:

    #1 cnr141, May 19, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    #2 Mike Kelly, May 19, 2015
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    I agree with Mike. retraction and temperature are the two parameters I would play with (more of the former, less of the latter).
     
    #3 mark tomlinson, May 19, 2015
  4. cnr141

    cnr141 Member

    Joined:
    Aug 6, 2014
    Messages:
    46
    Likes Received:
    0
    thanks guys.
     
    #4 cnr141, May 20, 2015
  5. tonycstech

    tonycstech Active Member

    Joined:
    Dec 16, 2013
    Messages:
    606
    Likes Received:
    196
    So how do u like that MK8 nozzle ?
     
    #5 tonycstech, Apr 7, 2018
  6. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    @tonycstech this was a dead thread and you will get no answer from the OP, he hasn't been active on this board since May 2015
     
    #6 WheresWaldo, Apr 7, 2018
  7. tonycstech

    tonycstech Active Member

    Joined:
    Dec 16, 2013
    Messages:
    606
    Likes Received:
    196
    great.
     
    #7 tonycstech, Apr 7, 2018
  8. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Any E3Dv6 nozzle is compatible with the Hexagon
     
    #8 WheresWaldo, Apr 7, 2018
Thread Status:
Not open for further replies.

Share This Page